How-To: Create a Simple Houseplant Wicking System

CRAFT: Crafty Travels

wickinghouseplants.jpg

My friend Goli recently went on a solo backpacking trip. When she returned she discovered that an unexpected heat wave had taken a toll on some of her plants. I volunteered to show her two very simple ways to keep her houseplants watered while she's off on her adventures. Cotton strips buried in the soil of each plant slowly wick water, keeping the root zone moist without leaving them soaked. A crafty little setup like this is super easy, and it's way cheaper than a house sitter!

Setting your plant directly into a tray of water might seem like a good solution when you are out of town, but that technique can easily "drown" the roots. Roots love oxygen, so sopping wet soil can cause rot, mold, and infection to set in. Using a simple wicking system means the dirt will have just the right amount of moisture. But always choose cotton — polyester just won't work the same.

wickinghouseplants_materials.jpg

Materials

Cotton fabric
Scissors
Houseplants

Large bowl of water taller than the plant's container
Small bowl of water smaller than your plant's container

Directions

Prepare the wicks:
Cut the cotton fabric into strips 1" wide, about 12" long.

wickingplants_step1.jpg

Method One

Step 1: Lay one end of the cotton strip on the soil. Wrap it loosely around the base of the plant's stem.

wickingplants_step2.jpg

wickingplants_step2b.jpg

Step 2: Use your finger to gently dig into the soil of the first plant. Try not to disturb the roots. Bury the end of the cotton strip in the dirt.

wickingplants_step3.jpg

wickingplants_step3b.jpg

Step 3: Fill the tall, large bowl with water, and set it next to the plant. Place the other end of the cotton strip in the bowl of water. Be sure that the strip increases elevation as it spans between the plant and the container of water. The water will slowly wick over, from the bowl to the soil, via the cotton.

wickingplant_step4.jpg

Method Two

Step 1: Wrap the wick loosely around the base of the plant, and bury its end in the dirt.

wickingplants_step5.jpg

Step 2: Place the free end of the wick in a bowl of water that is a tiny bit smaller than the width of the plant's pot.

wickingplants_step6.jpg

Step 3: Set the plant's pot in the bowl of water. You want the plant to rest in the bowl, but with a reservoir of water beneath it. The water will wick up through the cotton from the bowl of water under the plant.


Leave a comment




  • Crafty Chica Challeng: Love Shrine
  • UpCraft!

    Natalie Zee Drieu Natalie Zee Drieu
    Editor-in-Chief
    Twitter


    Becky Stern Becky Stern
    Associate Editor
    AIM Twitter


    Rachel Hobson Rachel Hobson
    Contributing Writer
    AIM Twitter



    Brookelynn Morris Brookelynn Morris
    Contributing Writer



    Katie Wilson Katie Wilson
    Designer



    Laura Cochrane Laura Cochrane
    Editorial Assistant


    Dale Dougherty Dale Dougherty
    Editor & Publisher
    Twitter


    Shawn Connally Shawn Connally
    Managing Editor
    Twitter


    Goli Mohammadi Goli Mohammadi
    Associate Managing Editor


    Arwen O'Reilly Griffith Arwen O'Reilly Griffith
    Staff Editor


    Lish Dorset Lish Dorset
    Contributing Writer
    Twitter