Hanna Perner-Wilson just released a kit version of her fabric bend sensor- everything you need to make one yourself!
This is a kit, meaning that it comes unassembled and requires you to have tools and some regular sewing thread as well as about half an hour time for completion.
This kit contains:
* Two 2 x 12 cm pieces of 1.5 mm thick HS quality neoprene with polyester jersey fused to each side (gray, purple)
* Two 1.5 x 9.5 cm pieces of Velostat
* Two 1 x 2 cm pieces of stretch conductive fabric with fusible interfacing adhered to one side
* 60 cm of conductive thread
* 1:1 Instruction stencil printout on A4 paper
To compete this kit you will need:
* Regular clothing iron
* About 60 cm of regular sewing thread
* Sewing needle
* Scissors for cutting thread
* Knife for cutting out stencil
* Pen for marking stencil
You can use her Instructable as a guide to construction.
All fixed, thanks for catching that! Try the link now.
Reply to this comment
The link on this craft to the Instructable goes to an error page that states "No Such Instructable." Neat item, anyway!
Reply to this comment